







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Mountain View: What the Job Actually Costs and How Long It Takes
A paver driveway in Mountain View usually runs $7,000 to $18,000 installed, and a typical two-car driveway takes four to six working days from demo to the final sweep of polymeric sand. The number that matters most is square footage: most Mountain View driveways land between 400 and 700 square feet, and paver work here generally prices out between $16 and $28 per square foot once base prep, edging, and drainage are included. Call (833) 988-3521 for a free on-site estimate with a written line-item quote.
How We Build a Paver Driveway, Stage by Stage

Paver work is mostly invisible. What you see is the top inch and a half. What keeps it flat and locked in for decades is the eight to twelve inches underneath, and that’s where the schedule actually goes.
Stage 1: Layout, utility locates, and demolition (day one)
We mark the driveway footprint and confirm the slope away from the garage slab before anything gets torn out. Underground service locates get called in and marked. Then the old surface comes out: asphalt, concrete, or existing pavers, loaded and hauled. On a 500-square-foot driveway, demo and haul-off is a single day. You decide two things before we start: the driveway’s exact dimensions and where the water needs to go.
Stage 2: Excavation and base grading (days two and three)
We dig down 8 to 12 inches depending on soil and traffic load, then grade the subgrade so water sheets toward the street or a drainage swale instead of sitting against the garage. Mountain View’s baylands-adjacent soils can hold moisture longer than inland lots, so we watch the subgrade closely after winter rains before we build on it. You approve the drainage plan at this point; adding a channel drain or a dry well later means cutting finished work.
Stage 3: Base compaction and edge restraint (day three)
Class II base rock goes in lifts of about 3 inches, each one compacted with a plate compactor. Then the edge restraint gets set and pinned in concrete along both sides. That edge is what stops the field from spreading under car tires. This is the stage where a cheap install starts to show, because skipped compaction is invisible until year three.
Stage 4: Setting bed and paver installation (days four and five)
An inch of washed sand gets screeded flat, then the pavers go down in the pattern you chose, cut tight around the apron and any curves. A 500-square-foot driveway is about two days for a full crew. You’ll want to have your pattern and color locked in well before this stage, because changing your mind here means pulling laid material.
Stage 5: Cutting, compaction, sand, and cleanup (day six)
Final cuts along the edges, two passes with a plate compactor over the finished field, then polymeric sand swept into the joints and set with a light mist. We clean the site and walk the driveway with you. Wait 24 hours before parking on it, longer if the weather turned wet.
If the driveway connects to a wider front-yard project, this often runs as part of a full Driveway & Pavers in Mountain View scope, which lets us coordinate grading and drainage across the whole hardscape in one pass.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
- Concrete pavers, standard grade: The workhorse choice for most Mountain View driveways. About $16 to $22 per square foot installed, holds color well, and any cracked unit can be lifted and replaced without touching its neighbors. Honest trade-off: the joints need sand topped up every few years.
- Concrete pavers, tumbled or premium finish: Runs closer to $22 to $28 per square foot. Better surface texture and a more settled look against mid-century ranch facades. The trade-off is cost and slightly more surface retention on steep aprons.
- Clay brick pavers: The classic look, and it holds color longer than concrete. Expect a premium over standard concrete pavers and a longer lead time. Suits an Eichler or ranch home where a warm, matte surface reads correctly.
- Permeable pavers with open joints: Worth pricing if your driveway drains toward the house or a low corner. They allow water to pass through the base rather than sheet across it. Costs more upfront, but can reduce the need for a separate drain line.
- Pattern choice: herringbone vs. running bond vs. basketweave: Herringbone is the strongest under vehicle tires; running bond and basketweave are simpler and faster to lay, which trims labor. A basketweave field with a soldier course border is a common Mountain View pairing for ranch homes.
What Paver Driveways Cost in Mountain View, CA

Installed paver driveways here run $7,000 to $18,000. That’s the range for a residential driveway, and most of the spread comes down to five variables:
| Cost factor | Low end | High end |
|---|---|---|
| Driveway size (400 vs. 700 sq ft) | $7,000 | $14,000 |
| Paver material grade | Standard concrete | Clay brick or premium finish |
| Existing surface and demo | Old pavers, easy pull | Thick concrete, rebar, haul-off |
| Drainage additions | Grading only | Channel drain or dry well |
| Site access and edge complexity | Straight run, open lot | Tight side yard, curves, curb cuts |
What’s included in our written estimate: demo and haul-off, excavation, base rock and compaction, edge restraint, setting sand, the pavers themselves, polymeric sand, final cleanup, and any permits we pull. What’s typically not: relocating an existing utility line, repairing a damaged garage slab or foundation at the apron, and any landscaping beyond the driveway edge. Those get priced separately once we see them, and we put them in writing before any extra work begins. Our pricing is upfront and no-surprise: the number you see is the number you pay, backed by 0% financing for 18 months and $1,000 off projects over $10,000.
See the difference
Before
After
Before
After
Before
AfterWhat Mountain View Homes Specifically Do to This Job
Mountain View is a collision of post-war Eichler and ranch tract homes with the highest concentration of tech money in the country, and that shows up in driveway work in ways it doesn’t in Los Altos or Sunnyvale. Most of the homes we do this job on are 1950s to 1970s single-story ranches on slab-on-grade foundations, often with an unpermitted converted garage or bonus room that has to be reconciled before inspection can close on anything attached to it. It’s common here to find an original concrete apron that’s been patched three times, which means the paver base has to be built up rather than cut down. The city’s inspection culture is unusually demanding because it’s both a historic suburban community and a global corporate headquarters town, so plan reviews are thorough and inspectors expect the drainage slope to be documented. We frequently see driveways near the baylands and creeks holding moisture well into spring, and winter rains expose grading and drainage problems that sat hidden all summer. If you’re covering Mountain View’s 94040 or 94035 ZIP codes, we’ll walk the lot, check the slope, and confirm what permitting applies before we quote.
Serving Mountain View, CA – Our Local Coverage Area
We serve Mountain View and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in Mountain View

A typical two-car paver driveway in Mountain View takes four to six working days from demo to final sand, and a larger or more complex driveway runs seven to eight days. Weather adds time in winter, since wet subgrade has to dry before base goes in. Call (833) 988-3521 and we’ll give you a firm schedule with your estimate.
Many residential paver driveways do not require a permit, but any change to a curb cut, a driveway widening, or drainage that ties into the storm system does. We confirm the permit scope before we quote so there are no surprises mid-job. Call (833) 988-3521 and we’ll tell you exactly what applies to your lot.
No, not correctly. Laying pavers over existing concrete traps water and creates a base that can’t be compacted, which causes settling and shifting within a few years. We tear out the old surface and build a proper compacted base, which is what makes the driveway last. Call (833) 988-3521 for a free on-site assessment.
Installed paver driveways in Mountain View run $7,000 to $18,000, with most jobs landing between $10,000 and $14,000 for a standard 500-square-foot driveway in concrete pavers. Premium finishes, clay brick, and drainage additions push toward the top of the range. Call (833) 988-3521 for an exact written quote, free of charge.
Every driveway we build is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That covers workmanship, and our technicians have up to 12 years of experience on paver installs. Call (833) 988-3521 to talk through the details on your project.
Homeowners often pair this with Door Installation in Mountain View when the front entry or garage door is getting a refresh in the same season, and with Cabinets & Countertops in Mountain View on larger renovations where the driveway is the last piece of the exterior to finish.
Get a Free Estimate for Paver Driveways in Mountain View
Call (833) 988-3521 for a free on-site estimate on paver driveways in Mountain View. We’ll measure the driveway, check the slope and drainage, look at what’s under the existing surface, and confirm the permit scope. Then you get a written line-item quote with the price locked before we break ground. A live person answers around the clock, and our Driveway & Pavers service covers the full scope if you’re planning more than the driveway.
Written by the team at Groundwork Construction Co.












