







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Alum Rock, CA
Concrete driveways & concrete work in Alum Rock, CA typically run $4,500 – $12,000 for a full new driveway pour, and most residential jobs take 3 to 5 working days from demo to the first drive-on. On the acreage and hillside parcels toward Alum Rock Park, expect the higher end: longer drives, heavier loads at the garage apron, and drainage grading the flatland subdivisions never need. Call (833) 988-3521 for a free on-site estimate.
How we build a concrete drive in Alum Rock – the real sequence
Concrete isn’t complicated, but the order matters. Skip a stage and you’ll see the result in two winters as a spiderweb of cracks or a slab that settles at the garage door. Here’s what the week actually looks like on a typical Alum Rock pour.
- Day 1: layout and demo. We stringline the new drive, confirm the slope away from the house, and break out the old slab or cut back the dirt. For a standard two-car drive that’s a half day; a long rural drive out past the flatlands can take a full day. You decide the final width and where the apron meets the garage door – this is the moment before the dirt moves.
- Day 2: subgrade and base. We excavate to depth, then compact a crushed-stone base in lifts. This is where a hillside job diverges from a valley job: on Alum Rock Canyon lots we cut and grade for runoff, sometimes adding a shallow swale or retaining edge so winter storms shed water instead of pooling against the slab. You don’t decide much here – you just want it done right.
- Day 3: forms, rebar, and inspection. We set steel forms to the final shape and place rebar or mesh on chairs so it sits mid-slab, not on the dirt. If your job requires a City of San Jose permit, this is when the pre-pour inspection happens. Plan on a day of float here – inspection schedules dictate the pour day, and we don’t pour without sign-off.
- Day 4: the pour and finish. We pour, screed, float, and choose the finish – a broom texture for the main run, a smooth trowel or exposed-aggregate band at the apron if you want a cleaner look. Control joints get cut in during the finish stage while the concrete is still green.
- Day 5 onward: cure. The slab cures for 5 to 7 days before vehicle traffic and up to 28 days to reach full strength. We seal it after curing, and you keep foot traffic off for the first day or two. That’s the whole job – about a week of work, and a driveway that should outlive the mortgage.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The choices that actually matter on a concrete pour
Most of the decisions happen in the estimate, not on the job site. Here’s what we walk Alum Rock homeowners through before a single form is set.
- Thickness. 4 inches is standard for a passenger-car driveway; 5 to 6 inches is what we recommend on acreage properties where a truck, trailer, or heavy equipment rolls in. The thicker slab costs more in concrete but holds up to loads the 4-inch pour won’t.
- Reinforcement. Rebar is stronger than wire mesh and the only choice we’d trust on a long rural drive. Mesh is fine for a short flat run on a tight infill lot. We’ll tell you which your site needs.
- Finish. A broom finish grips wet tires and hides wear – the default for most homes here. A smooth or exposed-aggregate finish looks sharper at the garage apron but is slicker in rain, so we usually keep it to the first few feet.
- Color and stamping. Integral color or a stamped border adds a finished look and roughly 15 to 25 percent to the raw concrete cost. We keep the stamped band to the edges on a working driveway so the main travel surface stays functional.
- Drainage detail. On the canyon-side streets this is the big one – a graded crown, a channel drain, or a retaining edge decides whether runoff runs to the street or under your slab.
When the concrete is one piece of a larger front-yard rebuild, homeowners often pair this with our Driveway & Pavers service for walkways and borders, or with Door Installation in Alum Rock if a new garage door is going in after the pour.
What Concrete Driveways & Concrete Work costs in Alum Rock, CA

Expect $4,500 to $12,000 for concrete driveway installation in Alum Rock. A straightforward flat-lot replacement sits near the bottom of that range; a long rural drive or a graded hillside pour lands at the top. Here’s what moves the number:
| Line item | Typical range |
|---|---|
| Concrete driveway installation | $4,500 – $12,000 |
| Driveway replacement (demo + new pour) | $5,000 – $14,000 |
| Driveway sealing (after cure) | $250 – $700 |
- Size and length. A standard two-car drive near the flatlands is roughly 400 to 600 sq ft; an acreage property with a long service drive can double or triple that, and concrete is priced by the square foot.
- Existing condition. Demo of an old slab, tree roots, or an unstable subgrade adds excavation time and haul-away. Flat lots are cheaper; a hillside cut with retaining work is not.
- Grading and drainage. This is where Alum Rock Canyon jobs climb toward the high end – extra site prep, swales, and retaining edging the flat subdivisions never need.
- Finish. Broom is baseline; stamped borders and integral color add roughly 15 to 25 percent.
- Permit scope. A new or replaced driveway may require a City of San Jose permit depending on the work; we tell you up front whether yours needs one and pull it if it does. That’s a real line in the estimate, not buried.
Every written estimate is itemized – concrete, base, rebar, finish, permit, disposal – so the number you see is the number you pay. If a driveway is part of a full Driveway & Pavers in Alum Rock project, we scope the whole thing on one estimate.
See the difference
Before
After
Before
After
Before
AfterWhat Alum Rock homes specifically do to this job
This is foothills-edge San Jose, ZIP 95127, where flatland tract subdivisions meet the Diablo Range. On the flat streets of mid-century ranch homes and 1960s-to-80s stucco houses, we mostly pour standard replacements and short new drives – the work is straightforward and the soil is predictable. Head up toward Alum Rock Canyon and everything changes: lots are steep, winter runoff races down canyon-side driveways in a few hard storms, and a pour at the garage apron has to be graded for drainage and held with retaining walls or extra site stabilization the flat subdivisions never need. Permits and inspections still run through the City of San Jose, but the defensible-space and slope questions shift block by block as you climb toward Alum Rock Park. The most common failure we see on the older flat-lot homes is a drive that’s cracked and settled at the garage because the original pour was thin and the base was never compacted – which is also why we won’t quote a replacement without checking the subgrade first.
Serving Alum Rock, CA – Our Local Coverage Area
We serve Alum Rock and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in Alum Rock

Most jobs run 3 to 5 working days from demo to finished slab, plus 5 to 7 days of curing before you drive on it. Hillside jobs with extra grading or a waiting permit inspection take a few days longer. Call (833) 988-3521 and we’ll give you a schedule with your estimate.
Sometimes. A new or replaced driveway may require a City of San Jose permit depending on the scope, and we tell you whether yours does before we start. We pull the permit and schedule the inspection when one’s needed. Call (833) 988-3521 to find out what your project needs.
Usually, yes. A driveway replacement is isolated to the drive and the base beneath it – we don’t touch plumbing, electrical, or the house structure unless there’s a specific problem. If a new garage door is part of the plan, homeowners often pair the pour with ADU Site Prep & Utilities in Alum Rock work for the utilities on larger builds. Call (833) 988-3521 for an exact quote – estimates are free.
Concrete driveway installation runs $4,500 to $12,000 in Alum Rock, and replacement with demo runs $5,000 to $14,000. Length, grading, finish, and permit scope move the number. Call (833) 988-3521 for a written, itemized estimate.
Our work is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in residential construction. We stand behind the pour in writing; call (833) 988-3521 to start.
Get a free estimate for Concrete Driveways & Concrete Work in Alum Rock
Call (833) 988-3521 for a free on-site estimate on Concrete Driveways & Concrete Work in Alum Rock. A live person answers, day or night, and we’ll walk the site, check the subgrade, and hand you an itemized quote – no surprises, no change orders. We’re glad to cover the whole Alum Rock area and nearby San Jose, and if a driveway is part of an ADU build, we can scope ADU Site Prep & Utilities in Alum Rock at the same visit.
Written by the team at Groundwork Construction Co. of San Jose.












