







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Gilroy, CA: What It Costs and How It’s Done
Asphalt Driveways & Resurfacing in Gilroy typically runs $3,500 – $9,000 for a new asphalt driveway and $250 – $700 for sealing, with a full tear-out and replacement of an old driveway landing in the $5,000 – $14,000 range. Most residential jobs take two to three days of actual work, plus a cure window before you park on the surface. Call (833) 988-3521 for a free on-site estimate with a written line-item quote before anything gets scheduled.
How We Install and Resurface an Asphalt Driveway

Asphalt is not a one-day job, and any contractor who tells you otherwise is skipping steps that show up as cracking two summers later. Here’s the real sequence we walk Gilroy homeowners through.
Stage 1: Site visit and moisture check (day 0)
We measure the driveway, check the subgrade, and look at where water currently runs off. On Gilroy lots that back onto orchards or open ag land, we also note wind-borne dust and drainage patterns from the neighboring field, because both affect how the base gets built. You leave this visit with a written scope and a fixed number.
Stage 2: Demo and excavation (day 1, half to full day)
The old surface comes out, whether that’s failing asphalt, cracked concrete, or a gravel base that’s been there since the ranch house was built. We excavate down to stable subgrade, typically 6 to 8 inches for a residential drive. This is the stage where an old driveway surprises you: soft spots, buried tree roots, or a section of original farm-lot fill that never got compacted. That’s a conversation, not a surprise invoice.
Stage 3: Base, grading, and compaction (day 1 into day 2)
Class II aggregate base goes down in lifts and gets compacted with a plate or roller, then graded so water sheds away from the garage and toward the street or a drainage point. Base is the single biggest predictor of how long the asphalt lasts. We don’t rush it, and we don’t thin it to save a load of gravel.
Stage 4: Paving (day 2 or 3, depending on size)
Hot-mix asphalt goes down at 2 to 3 inches compacted for residential driveways. In Gilroy’s summer heat we schedule paving early in the morning, because the mix needs to be workable and the roller needs time before the surface starts to stiffen. You choose the finish at this stage: standard dense-graded mix for most driveways, or a coarser mix on steep or heavy-use sections.
Stage 5: Cure and seal (day 3, then weeks later)
You’ll stay off the new asphalt for 24 to 48 hours, and we recommend keeping heavy vehicles off for longer. A first seal coat usually goes on 6 to 12 months after installation, once the asphalt has cured and the oils have weathered. After that, resealing every two to three years keeps it watertight.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for a Gilroy Driveway
- New asphalt paving ($3,500 – $9,000): The most economical hard surface per square foot. Best when the existing base is sound or the lot is being built fresh. Trade-off: it needs resealing every two to three years, and Gilroy’s summer heat means it will soften slightly on the hottest afternoons.
- Full replacement ($5,000 – $14,000): Tear out, new base, new asphalt. The right call when the old drive is cracking in a pattern that points to base failure, not surface wear. More disruption, but it resets the clock completely.
- Overlay resurfacing: A fresh asphalt layer over a structurally sound existing drive. Cheaper per square foot than a tear-out, but only works when the base is intact. On a 40-year-old ranch driveway in the 95020 area, we usually find it isn’t.
- Seal coating ($250 – $700): The maintenance item, not a repair. It protects against water intrusion and UV, and it’s the single cheapest way to extend the life of a driveway you already have.
- Edge restraints and drainage: A concrete curb along the sides and a proper swale or channel drain at the garage apron. Small line item, big effect on how long the asphalt lasts.
If your project also includes hardscape, walls, or a wider yard rebuild, that work sits inside our Driveway & Pavers in Gilroy scope, and we’ll write it into the same estimate so you’re not coordinating two contractors.
What Asphalt Driveways & Resurfacing Costs in Gilroy, CA

| Line item | Typical Gilroy range |
|---|---|
| New asphalt driveway paving | $3,500 – $9,000 |
| Full driveway replacement (demo + base + asphalt) | $5,000 – $14,000 |
| Seal coating | $250 – $700 |
Five variables move that number. Square footage is the first: a two-car ranch drive near downtown is a fraction of a long, wide approach on a larger lot out toward the 101/152 edges. Existing condition decides whether you get an overlay or a tear-out, and those are very different budgets. Base work – soft spots, added aggregate, extra excavation – can add meaningfully when the subgrade is bad. Access matters too: a narrow gate or a tight turn for the paving equipment slows the crew down. And drainage or grading changes, such as adding a channel drain at the garage, add cost but prevent the water problems that ruin asphalt first.
Every written estimate covers demo, haul-off, base material and compaction, asphalt, grading, and cleanup. What it doesn’t cover unless we scope it: drainage tie-ins to an existing system, relocation of utilities or irrigation lines, and any permit fees your project triggers.
See the difference
Before
After
Before
After
Before
AfterWhat Gilroy Homes Specifically Do to This Job
Gilroy’s older housing stock is the reason most of our asphalt calls here aren’t simple seal jobs. The ranch homes and farmhouses on large lots near the historic downtown have driveways that were poured or paved decades ago, often on a base that was never engineered as a proper driveway base. We see the same failure modes: alligator cracking from a base that’s given up, edge crumbling where the asphalt meets soil, and ponding at the garage apron because the original grading drained toward the house, not away. Newer tract subdivisions pushing out toward the 101/152 edges are a different story – the base is usually fine, so those jobs lean toward maintenance sealing rather than replacement.
The other local wrinkle is jurisdiction. Gilroy sites straddle city and county lines and Ag Preserve zoning, so whether your driveway needs a permit and what setback applies can differ block by block. On lots that back onto orchard or open ag land, we also plan for wind-borne dust during the base and paving stages, and we make sure grading sends water toward a legitimate drainage point rather than the neighboring field. If your project widens into a detached shop, garage conversion, or outbuilding, that work needs separate sign-off from the main-house permit and often pairs naturally with our ADU Site Prep & Utilities in Gilroy work.
We cover all of Gilroy, from the 95020 and 95021 ZIPs through the surrounding unincorporated pockets, and our Driveway & Pavers team handles the broader hardscape scope when you want it done in one pass.
Serving Gilroy, CA – Our Local Coverage Area
We serve Gilroy and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Asphalt Driveways & Resurfacing in Gilroy

Most residential asphalt driveways take two to three working days for demolition, base, and paving, then 24 to 48 hours of cure before you drive on it. Larger drives or ones needing substantial base work can stretch to four or five days. Call (833) 988-3521 and we’ll give you a realistic schedule for your specific lot.
It depends on whether your project changes the footprint, affects drainage, or crosses into county or Ag Preserve jurisdiction. A straight replacement in the same footprint often doesn’t need a permit; a new or widened drive usually does. We check your parcel’s jurisdiction before quoting, and we pull the permits and pass the inspections when they apply.
Sometimes, yes. An overlay works when the existing base is structurally sound and the cracking is surface-level. If the cracks run in an alligator pattern or the edges are crumbling, the base has failed and an overlay will just crack through within a season or two. We’ll tell you honestly which one you’re looking at.
Seal coating runs $250 – $700, and a full overlay or replacement runs $5,000 – $14,000 depending on size and base condition. New asphalt paving from scratch is $3,500 – $9,000. Call (833) 988-3521 for an exact quote – estimates are free and the pricing is written out line by line.
Every asphalt job we do is covered by our 730-Day Done Right Promise. If something isn’t done right, we come back and make it right. That’s in writing, and it applies to base work, paving, and finish grading alike.
Get a Free Estimate for Asphalt Driveways & Resurfacing in Gilroy
Call (833) 988-3521 and a live person picks up, day or night. We’ll set a time to walk your driveway, check the base, and talk through what it needs. You’ll get a written line-item estimate, fixed pricing with no change-order games, and a clear answer on whether you’re looking at a seal, an overlay, or a full replacement. Homeowners often pair this with Chain Link Fence in Gilroy along the property line, and we’re glad to scope both together.
Written by the team at Groundwork Construction Co.












